405 CAM - A workhorse, producing a wide powerband increasing torque and HP throughout the entire RPM range when compared to stock. Direct bolt in replacement for Milwaukee Eight engines, can be used with stock valve springs, pushrods, lifters and exhaust. Will respond well with slip-on mufflers and or complete exhaust system and a high flow air cleaner. Note Feuling recommends using free flowing mufflers with smaller cores for best lower RPM power and pull. RPM range 1,700 - 5,700. Grind: 405

Intake: .395 Valve Lift, 4 Open, 24 Close, 200 Duration @ 50, .068 lift @ TDC, 103 Lobe Centerline
Exhaust: .405 Valve Lift, 36 Open, 11 Close, 205 Duration @ 50, .049 lift @ TDC, 108 Lobe Centerline
Overlap: 7

*Cam specs measured in the engine on the lifter @ 0.050 using a 1.61 rocker arm ratio


DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VECHICLE

Feuling does not recommend tuning beyond stock emissions standards.

FITS:

Milwaukee Eight 17 - 22, 405 grind cam, 395 Intake lift, 405 Exhaust lift, direct bolt in replacement chain drive, can be used with factory valve springs, pushrods and lifters. RPM 1,700-5,700

COUNTRY OF ORIGIN:

USA

Disclaimer: Qualified Manufacturer Declared 49-State Federal Emissions Compliant Part (Not legal for sale or use in California) means any aftermarket part intended to replace an original equipment emissions-related part and that meets all EPA emission regulations by installing the element of design in all emissions-related respects to the certified configuration of the vehicle, engine, or piece of equipment. This manufacturer has declared in writing that it has fully documented the emissions testing of an appropriate test vehicle, engine, or piece of equipment that had been identically altered and that the part meets all applicable emissions standards for that make/model/year fitment(s) advertised.